Rev. 5/12
Page 11 of 15
SB
11634.10
Step 28. Remove the rear factory ares. The ares
are held in by 10mm nuts inside and on
the ends of the wheel opening.
Step 29. At the bottom front of the rear wheel well
opening measure forward 2 inches and
place a mark. Repeat for opposite side.
Step 30. Starting at the mark made in the previous
step continue following the contour up
maintaing a 2 inch distance from the
wheel well. The line shall continue to 1
inch past the door opening. Repeat for
opposite side.
REAR FLARE INSTALLTION PROCEDURES
Comments to this Manuals