Rugged-ridge Ultra Front Seat, Reclinable, Gray, 97-06 Jeep Wra User Manual download pdf (Page 3)

Page 3 of 4

Part Number: 13412.XX, 13414.XX, 1315.XX, 13416.XX

Seat Installation Instructions - MultiMount System (97-06 TJ) (84-01 XJ)

Pg.3

(84 - 96 XJ) : Place onto factory seat riser. Secure seat to base using (4) original nuts removed

in step #2 and supplied M13 at washers. (NOTE: riser will have mounting studs

entering step brackets at an angle). A small amount of thread lock should be

placed onto riser studs. Tighten all nuts and bolts to 27ft-lbs. Install plastic cover

plate and adjuster knob to seat (Fig.18 - 19).

Step 8: (03-06 TJ/LJ ONLY) - Before installing seat into vehicle remove the front lower 7/16” caps head bolt from

seat base (Fig.16). reinstall seat belt using at washers and wave washer saved in step #4. Tighten to

30ft-lbs. Plastic seat frame cover will need to be cut to clear seat belt bracket (Fig.17). Install plastic

side cover plate and adjuster knob to seat (Fig.18 - 19). Note: A 7/16” at washer may be needed for

some late TJ models. This washer will need to be sourced. Not supplied with seat hardware.

Step 9: Place new seat and seat riser into vehicle. Reinstall mounting bolts from step #1 and tighten to

30ft-lbs (Fig.18) Reconnect seat belt warning light if equipped (Fig.20). Repeat steps 1-9 for other side.

(03 - 06 TJ/LJ) : Place (1) spacer between seat base and riser. Insert nut plate and secure riser

to seat with (1) M13 bolt and washer. A small amount of thread lock should be

placed onto M13 bolts. Repeat for other 3 locations making sure seat is

positioned correctly before tightening bolts to 27ft-lbs (Fig.14). Move seat

cable to new location on factory seat riser (Fig.15)

Fig. 13

Fig. 14

Fig. 15

Fig. 16

Fig. 17

Fig. 18 Fig. 19 Fig. 20

1 2 3 4

No comments

Rugged-ridge Ultra Front Seat, Reclinable, Gray, 97-06 Jeep Wra User Manual Page 3