Rugged-ridge Fender Flare Kit, 10-14 Ram 2500 and 3500 Pickups User Manual download pdf (Page 2)

, Inc.

460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]

All Terrain Flares 10-14 Ram 2500/3500

3. Remove four factory installed screws with 8 mm

socket wrench. Save factory screws, they can be

used in installation. Remove plastic piece at bot-

tom rear of wheel well (2011-2014 only).

1. Install supplied bolts, washers, and locking nuts into

each are.

2. Clean inside of top lip edge with rubbing alcohol.

Install edge trim by removing red vinyl tape covering

only a few inches at a time. Applying adhesive side

of edge trim to inner side of are. Install edge trim to

the top edge of are (the edge that contacts ve-

hicle). Do not stretch trim while being applied. Trim

excess from ends.

Page 2/5

81630.43

Inner Flare Surface

Washer

Bolt

Nut

1 2 3 4 5

No comments

Rugged-ridge Fender Flare Kit, 10-14 Ram 2500 and 3500 Pickups User Manual Page 2