Rev (1) 10/13/09
2007-2010 JK Mirror kit w/ LED turn indicator
FIG 1
FIG 2
FIG 3
11002.14 11010.14
11002.15 11010.15
11002.22 11010.16
Page 2 of 2
STEP 9.
Thread a rubber grommet
around the wires and install
one on each hole drilled
through the metal section of
both doors. Route the wire
through the factory wire loom
on the door.
STEP 11.
Repeat step 10 on the
passenger side with the
exception of 1/2" to the
right of the rib.
STEP 10.
Pull the carpet back behind the
brake pedal on the drivers side
floor. Locate the raised rib on the
floor pan. Drill a 1/4" pilot hole 1/2"
to the left and even with the top of
the rib. Finish hole with a 1/2" drill
bit. Place a rubber grommet in the
hole.
STEP 12.
Route a red wire from inside of the
vehicle through the hole of the
floor board to the front turn signals
in the grill. This will need to be
done for both side. The wheel well
liners will need to be pulled down
slightly to run wires.
STEP 13.
You will now need to terminate each end of the wires starting with the mirror
heads. Install a short clear rubber boot on both the red and black wires of both
mirror heads. (Note: The Yellow Wire Will Not Be Used). Cut eight 1/2" long
pieces of shrink tubing. Install one piece of shrink tubing on each wire of the
mirror heads. Crimp on a male bullet connector on each mirror head wire. Slide
the shrink tubing over the crimped section of the wire and heat to seal the
connection. Now slide the clear boot over this section. Reapeat the same
procedure for the wires on the outside of the door using the longer boots with
the female bullet connectors.
STEP 14.
The wires extending out of the lower inside section of the door will receive a
four pin male connector. First crimp the female brass spade connectors on the
door wires. Insert the female spades into the four pin connector making sure
they click in and are secure. Next crimp a blue ring terminal on a 8" piece of
black wire and securing it to the grounding points located on each kick panel.
Crimp on the brass male spade connectors and insert them into the female
four pin connector corresponding postions as to the male four pin connector.
Now plug the two, four pin connectors together insuring proper fit.
(Note: Gound Wire Must Make Good A Connection To Function Properly).
STEP 15.
Locate the three pin connectors on each of the turn signals in the front grill. On
the driver side turn signal the lower position wire will be used. ( White with
Green stripe ) Using a blue splice connector, splice the red wire to the turn
signal wire. On the passenger side the upper postion wire will be used. ( White
with Brown Stripe )
STEP 16.
Start vehicle and test turn signals for correct function.
(3 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals