Rugged-ridge Deluxe Carpet Kit with Adhesive, Honey, 97-06 Jeep User Manual download pdf

P/N: 13690.XX , 13691.XX (without adhesive)

P/N: 13695.XX , 13696.XX (with Adhesive)

Applications: 1976 - 1986 CJ7 and 1987-2006 standard 2dr Wrangler

Jeep® Carpet Kit - Installation Instructions (1976-2006) CJ7 - Wrangler

Contents:

(1) Front floor cover

(1) Center floor cover (behind front seats)

(1) Rear floor cover

(2) Fender well covers (LH,RH)

NOTICE: For best results a quality spray adhesive must be used to install this carpet kit.

This adhesive may be found at most large hardware stores or fabric suppliers.

WARNING: DO NOT AIR SHIP CARPET KIT

. Some kits may include

adhesive that can not be shipped via air freight.

Step 1: Remove front and rear seats to ease installation. Clean

all mounting surfaces. Make sure work area is dry before

carpet is installed. If needed remove shift boot covers.

Step 2: Test fit carpet into place as seen in image #1. Make

sure that all carpet pieces are supplied in kit.

NOTICE: Carpet is supplied with no precut holes or notches.

Because of the different variations over the years this

task must be performed at the time the carpet is installed.

WARNING: Before applying spray adhesive make sure that

work area is properly ventilated.

Step 3: Remove carpet and proceed with the installation of the

LH and RH fender well covers. Mark location of side roll

bar and cut only the amount of carpet needed to allow for

a flush fit. Spray back of carpet with adhesive and slide

into place. Repeat for other side.

Step 4: Install rear lower carpet set. Mark hole locations for seat

and seatbelt mounting points. Only cut what is needed to

expose mounting holes. Apply adhesive and slide into

Place.

Step 5: Install center carpet section. Mark seat and seatbelt holes

if needed and only cut what is needed to expose mounting

holes. Apply adhesive and slide into place.

Step 6: Install front carpet section and mark holes as needed for seats

and shifter knobs. Mark holes as shown and only cut what

is needed to expose mounting holes and shift pattern. If

needed cut slits at front LH and RH side tub support brackets.

Make sure carpet does not interfere with pedal operation and

cut to clear if needed. Apply adhesive and slide into place.

reinstall seats and shift boots.

Page 1

PAGE 1

Tools needed:(1) Box knife

(1) Marker

(1) Spray

Adhesive

Summary of Contents

Page 1

P/N: 13690.XX , 13691.XX (without adhesive)P/N: 13695.XX , 13696.XX (with Adhesive)Applications: 1976 - 1986 CJ7 and 1987-2006 standard 2dr WranglerJe

Comments to this Manuals

No comments

Rugged-ridge Deluxe Carpet Kit with Adhesive, Honey, 97-06 Jeep User Manual

Browse online or download User Manual for For the car Rugged-ridge Deluxe Carpet Kit with Adhesive, Honey, 97-06 Jeep. Rugged Ridge Deluxe Carpet Kit with Adhesive, Honey, 97-06 Jeep Wrangler (TJ) User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Rugged-ridge Deluxe Carpet Kit with Adhesive, Honey, 97-06 Jeep